Bearings success story
<p style="text-align: center;"><img src="/ueditor/php/upload/image/20210517/1621236071528301.png" title="1621236071528301.png" alt="6.png"/></p><p>In a recent case study, Auburn Bearing & Manufacturing worked on an application involving custom screw driving spindles. The thrust bearings are located on shafts that are parallel to each other on 0.750in centre lines.</p><p><br/></p><p>The customer had been purchasing a standard-sized miniature thrust bearing from a large bearing manufacturer for many years. The three-piece bearing was being used in a fairly high volume (20 to 30 bearings per month) in the custom screw driving equipment and was being replaced on a regular basis.</p><p><br/></p><p>Because of the bearing¡¯s open style, it is subject to all sorts of contaminates and hard to keep grease in. The bearings needed to be completely taken apart and lubricated on a weekly basis. With this weekly maintenance, the typical life of each bearing was three months, and at the end of its life, significant wear was visible on all components of the bearing.</p><p><br/></p><p>The customer, Bemis Manufacturing, approached Aurburn Bearing frustrated by the loss of time and productivity it was experiencing from replacing a significant amount of prematurely failing miniature thrust ball bearings. It was looking for a new solution that would extend the bearing¡¯s life by keeping lubrication in and keeping debris out, as well as reduce the downtime and inconsistencies caused by these bearing failures.</p><p><br/></p><p>Auburn Bearing proposed a one-piece banded thrust ball bearing that would use a special lubricant. This custom design would serve to protect the bearing from debris and other contaminants as well as contain the grease inside the bearing. After a three-month trial run using this new solution, the customer found that the bearing race and balls remained in great condition without having to perform any maintenance on them.</p><p><br/></p><p>¡°Frankly, I don¡¯t pay much attention to these bearings any longer. With the new design, it has gone from a headache to a non-issue. Therefore, I would rate this a great success. These bearings have proven to be far superior to our current option. Machine consistency is the biggest improvement. Also, the inability for a maintenance person to assemble the old three-piece bearing incorrectly. The custom solution was by far the better solution to anything I could find on the market. I will certainly reach out to Auburn for future custom issues," comments Brett S., Engineering Manager, Bemis Manufacturing</p><p><br/></p>
17 May,2021
