NEWS

Turbo Bearings from MinebeaMitsumi

High heat resistant ball bearing units for automotive turbochargers. MinebeaMitsumi has improved combustion efficiency and reduced the time lag between the pedal operation and automobile acceleration by adopting high-heat resistant ball bearings instead of oil-lubricating bearings.      <img title="" alt="" src="http://www.bearing.com.cn/membcentre/editor/attached/image/20190528/20190528104744_95910.jpg" width="700" height="290" />  Three shaft diameters, 6 mm, 10 mm and 12 mm, are available. Displacements from 1.4 to 10 L are supported.   <o:p> A turbocharger harnesses exhaust gas pressure emitted from the engine cylinder to drive a turbine and a compressor mounted on the same shaft. Air taken in by an automobile is compressed by the compressor and sent to the cylinder, which increases air intake and improves combustion efficiency. The turbine and compressor both play important roles to efficiently send compressed air to the engine. In 2008, MinebeaMitsumi started developing a new type of bearings for a turbine main shaft that directly influences the rotational efficiency.   For years, many turbochargers for general automobiles used oil-lubricating bearings that are highly resistant to harsh environments. These bearings are required to withstand ultra-high speeds of over 200,000 revolutions, while continuously immersed in oil.   <img alt="" src="http://www.bearing.com.cn/membcentre/editor/attached/image/20190528/20190528105139_68782.jpg" />   <o:p> However, since the friction resistance of oil-lubricating bearings increases at the time of acceleration and deceleration due to its structure, the speed following capability is inferior to that of ball bearings (particularly when an engine starts at the low temperature). This generates a time lag between the increase in intake air pressure and the step-in operation of the accelerator pedal. Consequently, the driver feels the acceleration to be slow, and depresses the accelerator pedal more than necessary, thereby resulting in poor fuel economy. In actual city driving, since acceleration and deceleration are frequently repeated, a series of those steps tend to affect practical fuel economy. <o:p></o:p>  To address these issues, we had to improve the following four main points for the new type of ball bearing unit: Downsizing along with an engine unit downsizing, high durability, high-heat resistance and low torque. In addition, we had to mass produce the bearings so that they would be widely adopted for use in general automobiles and eco-cars. MinebeaMitsumi, which has been continuously improving bearing production technologies since its establishment, begun to tackle this challenge. <o:p></o:p>  Compared to oil-lubricating bearings, the structure of high-heat-resistant ball bearings is more complicated. <o:p></o:p>  <img alt="" src="http://www.bearing.com.cn/membcentre/editor/attached/image/20190528/20190528105253_22087.jpg" /> The challenge of durability and heat resistance was solved by combining parts made from different materials. For the inner race and outer race, we adopted M50 bearing steel that is also used for the main bearings of aircraft jet engines; and for balls, we adopted lightweight ceramic materials with low calorific value, suitable for high revolution. We also applied special surface treatment to the retainer to improve the balls </o:p></o:p>

28 May,2019

Previous： SMB Bearing:Bearing Beauty is Only Skin Deep
Next： Lucas di Grassi Wins Home Round for Audi Sport ABT Schaeffler